Servers by jDrones

ArduCopter   Copter 3.6


Topic Replies Activity
About the Copter 3.6 category 1 March 19, 2018
Anyone know how to use this 1 September 15, 2019
PIxhawk wont Disarm after Landing 17 September 15, 2019
Copter-3.6.10 released! 54 September 15, 2019
GPS config u-blox M8N 37 September 15, 2019
Autotune PID values 12 September 15, 2019
Sonar range check after flow install 3 September 14, 2019
Get the GPS accuracy via mavlink 19 September 14, 2019
Copter-3.6.9 Precision Landing Issue (IR-Lock) [Solved] 40 September 14, 2019
Can't throttle up beyond arming 8 September 14, 2019
Triple Redundant GPS With Pixhawk 4 September 13, 2019
Design verification: Octo with props on two planes 4 September 13, 2019
Bad Logging eating SD cards 4 September 13, 2019
Motors not spinning until >50% RC throttle 3 September 13, 2019
PID Error to Rate (Stabilize) 3 September 13, 2019
[Log Analysis] Questions about expected behavior on compass failure 2 September 13, 2019
MicroArduCopter, 3" props, Omnibus Nano, Success! 522 September 13, 2019
Reading Logs for Battery Failsafe Testing 72 September 13, 2019
Auto Mission not Continuing After Package Place Command 13 September 13, 2019
Drone unable to lift 8 September 12, 2019
Lightware SF11/C with IR Lock 3 September 11, 2019
Dual GPS with Belding from different vendors 7 September 11, 2019
Copter: onboard mag calibration does not start if HereFlow is used 1 September 11, 2019
RPLIDAR A2M8 360º Object Avoidance problems 10 September 11, 2019
Uncommanded assent 11 September 11, 2019
Faulty RC signals - Emergency stop 4 September 10, 2019
Quad copter started twitching hard 9 September 9, 2019
SBUS OUT on small FCs? 9 September 8, 2019
Endurance test ended with crash with Copter 3.6.9 11 September 7, 2019
How to shoot photo with ROS for geotag 2 September 7, 2019