Servers by jDrones

ArduCopter   Copter 3.5


Topic Replies Activity
About the Copter 3.5 category 3 July 19, 2017
Autonomous Drone Hovers Fine and then Drops Suddenly 2 February 22, 2020
Precision Landing Help needed 112 February 21, 2020
RC Override in Mavlink 9 February 14, 2020
Quadcopter suddenly falls 1 February 13, 2020
DesRoll and Roll too much difference 12 February 11, 2020
Current sense reading 0 10 February 10, 2020
Don't command RTL, Loiter and crash 1 February 10, 2020
Sending lidar data from pixhawk to raspberry pi 4 February 5, 2020
Issue trying to connect I2C OLED display to Pixhawk 18 February 3, 2020
About Lidar Lite v3 support 57 January 31, 2020
Lowbattery failsafe and crash 13 January 30, 2020
Sending commands via /mavros/setpoint_velocity/cmd_vel in guided mode 5 January 28, 2020
Teraranger Tower - Check Proximity Sensor Warning 4 January 28, 2020
Motors C & D on X frame spin faster than A & B causing flip on throttle up 9 January 26, 2020
I2C Maxbotix range finder on Pixracer 60 January 24, 2020
How to manually control a Hawkeye Firefly 6S? 12 January 23, 2020
Nasty problem in pre arm: duplicate aux switch options 11 January 21, 2020
Log analysis - unsuccessful take off - big oscilations 1 January 18, 2020
Safety switch vs arming 2 January 17, 2020
Thoughts on distance/altitude based intelligent battery failsafe 78 January 16, 2020
Maxbotic I2C sonar. Bad range of readings 1 January 15, 2020
Set Safety Switch via MAVLink 3 January 14, 2020
Simple script using mavros setpoint_position 19 January 12, 2020
Dual redundant compass issue (against failure NOT bad data) - Here with Pixhawk 2.1 8 January 7, 2020
RTL mode on channel 5 does not work 6 December 30, 2019
Unable to arm, but no error messages 9 December 28, 2019
Where to download Copter 3.5 for an original IRIS+ with a PixHawk 1. (1Mb) to support the Gripper 4 December 26, 2019
Can't set GPS_GNSS_MODE for Galileo on Ublox SAM-M8Q 7 December 19, 2019
No parameters SRx for telemetry port 4 and 5 6 December 17, 2019
Servers by jDrones