Servers by jDrones

ArduCopter   Traditional Helicopter


Read first: How to use this forum (2)
About the Traditional Helicopter category (1)
Helicopter Rotor Speed Governor (7)
Unexpected Heli RSC to Idle while in Auto Mission, FS_THR was correct? ( 2 ) (27)
Using Omnibus F4 V3 on a 450 helicopter, Yes or No (1)
Small Trad Heli Copter (15)
Best Pixhawk variant for 1200mm sized gasser heli ( 2 3 ) (41)
Heli drifts on Auto takeoff with AC 3.6.0 (16)
Compass learning (14)
Autotune on a helicopter? (4)
Gas Heli loosing altitude in Loiter (7)
Gasoline helicopter, check fuel level (4)
Vertical Control (climbing / descending) in Auto mode + others (8)
Need help with traditional helicopter's rpm ( 2 ) (24)
Goblin 380 High speed porpoise at 25 meters/sec (4)
APM heli analog tail servo moving real slow, Help Please (4)
Need Help for POS HOLD Mode (16)
Helicopter 3.6.0 Firmware can not get RPM information (7)
When Auto Mission Flight is not an automatic landing ( 2 3 4 ) (60)
Motor will not shutoff on auto land disarm (5)
Initial Setup of Pitch and Roll Tuning Parameters (14)
APM 2,6 can I use a digital and analog servos on the same heli? (1)
Mission Planner screen condition is abnormal (3)
Help needed to tune a flybar 600 nitro heli ( 2 ) (29)
Params check please ( 2 3 ) (58)
Pixracer & futaba TX6 (6)
Setting Throttle Mid (aka Hover Throttle) (6)
Altitude control parameters (5)
Trad Heli Attitude controller requirements - Help Requested ( 2 3 4 5 6 7 8 9 10 11 ) (213)
Reverse Collective? (7)