Servers by jDrones

Hardware   Other Hardware


Topic Replies Activity
About the Other Hardware category 1 June 19, 2013
Thermal cameras? 3 July 22, 2019
Here+ base station showing wrong "Z Values" 3 July 21, 2019
Accurate elevations and geoid reference 1 July 19, 2019
drone height holding**Integration of Pixhawk and TF03 LiDAR sensor for altitude holding and localization 1 July 15, 2019
Omnibus F4 - Arducopter - no TX Signal via S-Bus and PPM 1 July 13, 2019
Telemetry Basic Questions 3 July 11, 2019
Popping Caps on ESCs - Faulty ESCs? Or Something in my setup? 8 July 4, 2019
F450 ESC burns when throttle applied 4 July 3, 2019
F411C/NOX support 11 June 30, 2019
Buzzer is beeping continuously even after boot-up on OmnibusF7V2 3 June 29, 2019
Smart battery BMS availability 6 June 27, 2019
OmnibusF7V2 is not detecting the compass 2 June 28, 2019
RFD900X PPM Pass through test 25 June 23, 2019
Using Mavlink Protocols on Teensy 3.6 5 June 10, 2019
Mateksys F405-STD resets to default settings by itself 2 June 9, 2019
S.port telemetry with Matek 405-wing 10 June 8, 2019
Good ideas for design of phone based control for 2-wheel robot? 12 May 29, 2019
Mateksys F405-STD external compass 5 May 29, 2019
LiDAR drone remote sensing 1 May 29, 2019
New GPS from CUAV 9 May 26, 2019
SWIR and thermal camera help ICI Cameras 2 May 24, 2019
RTK-GPS with APM3.1 or Omnibus F7 1 May 15, 2019
Suggestions on how to power 12v solenoids from Pixhawk please 7 May 7, 2019
Absolute accuracy of Here+ v2 RTK 5 May 3, 2019
Trouble getting correct voltage from Mauch HS-200-HV 2 April 28, 2019
HEX ProfiCNC Here2 GPS - a mystery 12 April 25, 2019
Power Module with ON/OFF Switch 14 April 18, 2019
Help! China Red brick 200amp ESC, will not initiate programming or run Mtr's 1 April 17, 2019
Bad LIDAR health with several different LiDARs 3 April 16, 2019