Servers by jDrones

Hardware   CAN Devices


Topic Replies Activity
About the CAN Devices category 1 December 4, 2018
AP_Periph 1.0.0 stable released 255 April 11, 2021
AP_Periph IMU UAVCAN 8 April 8, 2021
Custom Peripheral device using AP_Periph 2 March 30, 2021
No GNSS Fix with Matek M9N-CAN 2 March 29, 2021
3rd GPS sensor over CAN 2 March 26, 2021
Cables for Here 3 3 February 24, 2021
UAVCAN BMS Requirements 2 February 8, 2021
SERVO Output Node 3 February 3, 2021
Pixhawk 4 Mini with the Hereflow 3 January 27, 2021
Supported BMS systems 1 January 25, 2021
Honeywell RSC airspeed base on uavcan 5 January 15, 2021
Omnibusf4v6 UC: Failed to add Node 10 10 January 4, 2021
High performance IMU on UAVCAN? 7 December 28, 2020
Publishing autopilot on-board sensor data to CAN bus 2 December 11, 2020
Location One drops into Maintenance mode after extended periods with RTCM corrections 18 December 2, 2020
UC: Duplicate Node 12 October 6, 2020
Hereflow & with custom hardware 1 September 30, 2020
Hereflow was not detected problem 1 July 31, 2020
Multiple UAVCAN Power Modules 7 June 26, 2020
NEO V2 Pro GPS (UAVCAN) no gpsv_acc or gpsh_acc 1 June 3, 2020
Teraranger one sensor on can node 1 May 16, 2020
Need larger Data Frame 1 May 16, 2020
UAVCAN GPS Module 14 May 13, 2020
OlliW's New UC4H Rangefinder 7 May 8, 2020
Potential Design Flaw in CUAV CAN PMU 11 May 8, 2020
Using and Configuring Zubax GNSS 2 4 March 23, 2020
UC4H Mag calibration fails 12 March 2, 2020
HEX ProfiCNC Here2 official firmwares 2 February 10, 2020
Issue with Zubax Gnss 2 GPS when booting from Batteries and not USB 3 January 17, 2020
Servers by jDrones