Servers by jDrones

ArduCopter   Copter 4.0


Topic Replies Activity
About the Copter 4.0 category 4 May 28, 2020
Accuracy of altitude using RTK 13 August 5, 2021
Using ADSB to avoid from mavlink/mavros 5 August 5, 2021
Moving Baseline with only one serial 5 August 5, 2021
Slow yaw without stick input 8 August 5, 2021
Very New to ArduPilot and Stumped 14 August 4, 2021
High Speed Auto Mission 17 August 4, 2021
5in Freestyle Quad tuning Help 13 August 4, 2021
I2C OLED display question 4 August 4, 2021
How to do a circle in Guided mode with dronekit 1 August 4, 2021
I want to set my imu noise 0 in gazebo 1 August 4, 2021
Need suggestion on my Autotune Result 5 August 3, 2021
Frsky Archer R6 with orange cube 1 August 3, 2021
Battery Failsafe HUD Message 6 August 3, 2021
Oscillations while stablize/alt/loiter with 8 kg payload 15 August 3, 2021
Use INS position as backup/failsafe to GPS loss? 8 August 3, 2021
Loiter Oscilations and poor wind performance - Help with tuning quadcopter with 28" props 12 August 3, 2021
FFT from gyro - difference in FFT plot amplitude obtained after switching from Mission Planner 1.3.74 to 1.3.75 3 August 3, 2021
Servo5 vs Mot_PWM - how they differ? 1 August 2, 2021
NOTCH filter - how to filter spikes in two different frequencies? 4 August 2, 2021
Cube orange avec ESC Flame 280 A 1 August 2, 2021
Large Quad shakes 27 August 1, 2021
How to setup the BN-880 GPS Module? 20 August 1, 2021
I am not able to find hover_freq value in the mission planner 30 August 1, 2021
TriCopter tail servo servo_trim always reset 10 August 1, 2021
Battery saving optimal speed for a quadcopter 17 August 1, 2021
INS_HNTCH_MODE Parameter is not showing in the mission planner 25 July 31, 2021
Yuri's new project (ArduCopter Quad - now 4.1.0-beta) 26 July 31, 2021
Support for the Runcam protocol 22 July 30, 2021
Large Vehicle Mag Calibrate Problem 20 July 30, 2021
Servers by jDrones