TXMOD params resetting/not saving after power cycle

[xfacta (Shawn)]

Do you make the changes via the web interface of the TXMOD?
Check this process:

RFD900 / TXMOD and SBUS

I’m adding a “How-To” for the TXMOD and SBUS for RC control. I’m covering two aspects here: SBUS Increasing the baud rate - partially because that’s how I have mine set, so better to mention it now than have anyone confused by the screenshots, and partially because nearly everyone should update to the higher baud rates unless you fly very long distances On the air-side/remote radio you need the SBUS output connected to the RCin of your flight controller. It’s the same pin as for RC/PPM but t…

I suppose the next step is reloading the TXMOD firmwares? There are two bits to it…

Firmware | RFDesign Files

Otherwise email support@rfdesign.com.au