Have you sorted your throttle problem?
I am having similar issues.
I am using skid steer but have no output on the servo rail now.
It has been working fine.
I can see that the Cube is receiving the RC input but I have no output to the speed controller.
I can arm the vehicle no problem but still nothing.
Cheers,
Martin
Have the same problem. All working good for me and, one day, don’t know why, the throttle stop working for no reasons. The steering still work.
I already checked many thing, RC, armed/disarmed, Servo out etc…
Any ideas ?
Cand
Did you get yours working?
Mine has done it again.
It usually happens if you are using a non-bidirectional servo for a rover.
To solve this recalibrate the ESC, but the lowest point should be the middle position of your stick.
( when you give throttle it will still run from the bottom to the top )
To do this:
disable ALL safety features,
arm it
throttle up
plug the battery
wait for the ESC tone
pull down the throttle stick to the middle ( it helps if you have some visual confirmation with numbers on the TX LCD ).
It usually happens if you are using a non-bidirectional ESC for a rover.
To solve this recalibrate the ESC, but the lowest point should be the middle position of your stick.
( when you give throttle it will still run from the bottom to the top )
To do this:
disable ALL safety features,
arm it
throttle up
plug the battery
wait for the ESC tone
pull down the throttle stick to the middle ( it helps if you have some visual confirmation with numbers on the TX LCD ).