Hello,
I had a crash recently where I can only post the Telemetry log as during the flight i got bad logging message. Also the param file is attached.
What actually happened is upon take off I was flying without any issues, at about 10 meters drone was hovering. At that stage motors stopped and drone fell like a rock. All the failsafe functions were set properly including RC and battery.
Attached are the param and telemetry log file. I checked the power status but i cannot figure out why actually power is off as it seems pixhawk reboot itself. Since it is a pixhawk 1, could it be faulty hardware?
Thanks…
Telemetry Log
Parameter
param10042019.param (13.9 KB)