Log browsing is not working properly due to the lack of formatting (FMT) information in your logs. These seem to have been lost from your log.

ArduPlane
,
1

微信截图_20241025125108

https://drive.google.com/file/d/1LV53RC0aEaVQSVQSsaxk_jndT_lomn9q/view?usp=sharing

MP cannot read log file, prompt no FMT
I will use TEC_SYNAIRSPEED=1 to control the flight speed. After flying in circles for about 40 minutes, it was found that the airspeed began to decrease. I set it to 16M/S, but later it seemed to maintain a speed of 13M/S, which may cause stalling.
But I can’t load this log

2

Search this forum. One other user reported the same issue.