Endpoints in Q x 7 transis

Hello experts,

I am using hobbywing x6 motors… It has inbuilt esc…
But after reading the documentation i saw it pwm is constant ranging from 1100-1940.
I have q x 7 tx… I am trying to setup endpoints. I adjusted it’s endpoints in “OUTPUTS” section of q x 7.
Is this correct method?.
After adjust the pwm range… Q x 7 show little difference compared to mission planner radio calibration value… Why?


See this in q x 7 pwm value is 1946 while in mission plannee it is 1940 which one is true?

No. Nothing on the Transmitter. These parameters:
MOT_PWM_MAX
MOT_PWM_MIN

1 Like

Hello @dkemxr ,

Thank you brother :+1:.