Can not connect to mission planner with sik telemetry

ArduCopter
1

I bought two sik telemetry (100mw 433mhz).
I can read sik radio signal in mission planner.

제목 없음
제목 없음2193×1759 454 KB

But, i can’t connect to mission planner…

Can you help me?

2

There is not enough details for us to help you.

Explain exactly which steps you did.

3

Hi, amilcarlucas.
Sorry for not explaning exactly…

I followed the steps below:

  1. Received new modules (Sik telemetry).
  2. Connected Telemetry 1 to the PC using the included USB connector.
  3. Connected Telemetry 2 to the OrangeCube using the included JST connector.
  4. Powered the OrangeCube through the micro 5-pin connector.
  5. In Mission Planner, went to the “Additional Hardware” section and accessed the “Sik Wireless” settings to load the configuration for each telemetry.
  6. Verified that both telemetries were connected and that I could check the settings for both local and remote telemetry, with the LED status remaining green.
  7. Checked the default values for Net ID, BaudRate, Min, and Max Freq, and adjusted the Max value to be greater than the Min, as shown in the uploaded photo (see original post).
  8. After confirming the COM port of the telemetry connected to the PC in Device Manager, I configured it correctly in Mission Planner and clicked connect.
  9. While it seems like time synchronization is working (the time updates on the Mission Planner home screen), I cannot read the actual parameters, and I receive an error message as shown in the uploaded photo (see original post).

Can you help me with this?