Servers by jDrones

Voltage not reading

(Chris) #1

I am trying to get my Matek F405 CTR board set up with mission planner, and I am unable to get the program to see the voltage. Attempted to go through the wiki page, but still unable to figure it out.

Any thoughts?

I did just try and loading these parameters into mission planner… and nothing

it should work out of the box, the params are:

BATT_AMP_PERVLT 31.7
BATT_CURR_PIN,11
BATT_VOLT_MULT,11
BATT_VOLT_PIN,10