The vtol about flying wing

ArduPlane VTOL Plane
1

428696890861473603

29350183152727611
29350183152727611.jpg960×960 39.8 KB
480762302242765151
480762302242765151.jpg1440×1080 101 KB

Hi everyone:
My FC control is pixhack V3，I have burned program by QGC，and builded my vehicle，but I don’t know how to connect my servos（AIL&ELE）and thrust motor，I tried my beast but found nothing.If you know something about this please contact me, thanks!

2

Hi,

Assuming that you are using the APM stack and Plane firmware loads, use the following links in the Wiki for setup information. The SERVO1_FUNCTION corresponds to the S1 output on Pixhack.

Elevon Planes
QuadPlane Frame Setup

Use this link below for learning the entire QuadPlane setup.

QuadPlane Support

Cheers!

3

It’s my pleasure to get your reply,thanks for your help。 The problem has been solved，I’m going to fly next week！