Set up a battery monitor with special specifications

Hardware Other Hardware
,
1

Excuse me, recently using a high current resistant Battery Monitor
I refer to the following two URL settings

https://ardupilot.org/copter/docs/common-mauch-power-modules.html
But the values ​​are all weird.
The battery is two 22000mah/12s batteries connected in parallel.
However, when setting the parameters, the parameters are automatically changed all the time.
And the voltage and current display incredible values ​​(such as voltage display 53V; current display 131A)
My settings are as shown below
photo_6246910201684931793_x

I would like to ask if anyone has set up a more specific battery monitor, please give me some suggestions or references.

2

Do you have the paper that came with the Mauch sensor that shows it’s specific calibrated values?
You can use the full parameter list to enter the values directly into

BATT_VOLT_MULT
BATT_AMP_PERVLT

or you can enter the values as per this diagram in the documentation

image
image1010×639 101 KB

3

Thank you very much for your response
I will look up the paper that came with the Mauch sensor and modify the relevant parameters