Servos not working with 3.2.3

Archive
1

I just started playing with my PX4 hkflyer clone so the problem might be me.

Anyhow when flashing the latest firmware my servos stop working.
Going back to 3.1.1

I can provide whatever settings/logs you need - if you point me to how it’s done.

2

@excogitation,
RTFM: http://copter.ardupilot.com/wiki/common-downloading-and-analyzing-data-logs-in-mission-planner/#message_details_apmcopter_specific
Regards,
TCIII GM

3

@excogitation,

if this occurs after reset the parameters and calibrate the rc input, than take a look to RCx_TRIM parameters. If they are 0 set it to 1500.

I have observed a similar issue after calibrating RC inputs with 3.2.3.

Regards
Hxxnrx