Sending CanFD frame

ashely_hills · February 15, 2024, 2:43pm

Does anyone know how to send a canfd frame? I was going through the libraries to try to figure it out but my methods don’t work.

I use the examples found here

github.com

ArduPilot/ardupilot/blob/master/libraries/AP_Scripting/examples/CAN_read.lua

-- This script is an example of reading from the CAN bus

-- Load CAN driver1. The first will attach to a protocol of 10, the 2nd to a protocol of 12
-- this allows the script to distinguish packets on two CAN interfaces
local driver1 = CAN:get_device(5)
local driver2 = CAN:get_device2(5)

if not driver1 and not driver2 then
   gcs:send_text(0,"No scripting CAN interfaces found")
   return
end

-- Only accept DroneCAN node status msg on second driver
-- node status is message ID 341
-- Message ID is 16 bits left shifted by 8 in the CAN frame ID.
driver2:add_filter(uint32_t(0xFFFF) << 8, uint32_t(341) << 8)

function show_frame(dnum, frame)
    gcs:send_text(0,string.format("CAN[%u] msg from " .. tostring(frame:id()) .. ": %i, %i, %i, %i, %i, %i, %i, %i", dnum, frame:data(0), frame:data(1), frame:data(2), frame:data(3), frame:data(4), frame:data(5), frame:data(6), frame:data(7)))
end

This file has been truncated. show original

github.com

ArduPilot/ardupilot/blob/master/libraries/AP_Scripting/examples/CAN_write.lua

-- This script is an example of writing to CAN bus

-- Load CAN driver, using the scripting protocol and with a buffer size of 5
local driver = CAN:get_device(5)

-- transfer ID of the message were sending
local Transfer_ID = 0

-- RGB colours in 0 - 255 range, and RGB fade speed
local red = 255
local green = 0
local blue  = 0
local fade_speed = 5


function update()

  -- send UAVCAN Light command
  -- uavcan.equipment.indication.LightsCommand
  -- note that as we don't do dynamic node allocation, the target light device must have a static node ID

This file has been truncated. show original

And then I tried to set msg:canfd(true) but then the script crashes. Would appreciate any help