Sbus problem with Pixhawk and firmware 3.1.1

ArduCopter Copter 3.1
1

Configuration :
Radio FX40 Futaba
Receiver R6208SB (sbus not sbus2 the receiver and radio are linked and I checked that it is working with a digital servo on output)
pixhawk with last firmware 3.1.1 uploaded february the 8th with Mission planner 1.2.95 build 1.1.5150.11972

I don’t get any signal in Mission planner radio calibration.

I previously used a spektrum receiver with DX6I which worked fine but only 3 flight modes.

With this futaba and receiver I get no signal at all. My radio change goal was to have more flight modes enabled.

I did read the previous messages on same subject (upload last firmware, clear the sd card …) but it still does not work.

Thanks for your help.

2

Hi jps31,

Are you connecting to RC IN? SBUS is an output.

copter.ardupilot.com/wiki/common … _RC_inputs

3

Thanks for your answer.
I missed this page.
It is OK now.

BR