QGround Control

Hi all,

I have managed to flash the DroneBridge onto ESP32C3 board by Seeed Studio Getting Started | Seeed Studio Wiki. It was successful and I was able to connect to the wifi ‘DroneBridge ESP32’.

I then moved on to connect it to RX7, TX7 pins on MATEKSYS H743 Wing Flight Controller which is ‘Telem1’ for Ardupilot mapping. The issue that I am facing is that the QGroundControl keeps showing that the vehicle is disconnected.

The firmware loaded onto the flight contorller is ArduRover, and I was able to configure it using Mission Planner. I am trying to implement wifi telemetry for ease of use in the future.

I do not know how to troubleshoot further. Anybody have any advice on this? Thank you.