Power Module v1.0 - which end to connect battery

My Power module v1.0 looks similar but not like the ones I see on the set-up page, youtube etc. I’ll try to upload a pix. In the mean time, on the board where the wire leads come off of, there is a small arrow on one side of the board next to the wire leads pointing outwards (away from the board). Does this mean that the power flow is in this direction (coming in from the other side of the board’s wire leads - then thru the board - and finally out this side of the board’s wire leads) or is it the other way around? Thank you in advance.

  • Sam

I was stuck on this as well…
I found the below image and after that I removed the XT60 plugs and fitted a male XT60 to the battery side of the power module and soldered the other end direct to the +/- of the f550 bottom plate power distribution board…

hope this helps…