My mission planner dosen't receive RC signal

Ground Control Software Mission Planner
1

Hello. I am currently building Quadcopter using Pixhawk4, Mission Planner, and ArduPilot.
I’m using Radia Master’s TX6S controller and RX8R receiver(Frsky)

I’m trying to doing Radio calibration, but my pixhawk and mission planner can’t receive controller’s signal.

i think controller and receiver are connected well, and pixhawk and ardupilot are connected wel too.

is there way out for this problem?

2

It either is or isn’t bound. See here in the RC Input section it might help Pixhawk 4

3

Thank you for the advice.

I can see the movement of my Pixhawk in Mission Planner.

And My receiver is showing a green light, so I think the binding was successful.

Is there any other way to check if the binding is complete?

Could there be any other issues besides binding?

4

Yes

You only think, or you are 100% sure?
We only can guess as you don’t show how you connect the devices and also don’t shows your parameters

5

Thank you for the advice.

I find that My electric wire between receiver and pixhawk4 was broken

Thank you.