Mission Planner Terminal Continuous Generating Garbage Characters

Ground Control Software Mission Planner
1

Hello,

I have AMP 2.6 with 3.2.1 firmware.

When I open the Terminal in Mission Planner I can connect to the drone, and it gives a few messages about calibration and intialization - but then it just keeps generating tons of weird characters. I can type stuff in and hit enter but commands are ignored.

Any advice appreciated!

drone terminal garbage.png1362×478 31.4 KB

2

This is MavLink binary protocol you are seeing.
The CLI was removed from the APM firmware to save space and is longer supported.

3

Hey Mike,

Thanks for the reply.

Alex