Hi all. When I had Copter 3.4 installed I played around a lot with the perpetrators over several months. (did not note down what I was doing 
When I triggered the camera manually via ch7 there was a log entry of the manual trigger AND mission planner would place an icon on the map of the location at the time of trigger. We used this info to assist in our post processing on inspections.
Now I have installed Copter 3.5 this has gone. No icon in mission planner and no energy in the log for manual triggering.
I can only assume I set a arducopter 3.4 parameter(s) to enable this logging and send a message to MP when there is a cam trigger. Since this was some time ago I can’t remember how this worked and we took it for granted. Now I have no idea how this was setup.
there is no feedback from the camera, incidentally.
Any ideas. I do remember log mask was (and is now) set to nearly all 45054 which it is now in v3.5.
thanks