LOG_BITMASK Reverts to 0 after disconnecting

ArduCopter Copter 3.2
1

I’m having trouble enabling logging. Here is the process I’m following:

  1. I set LOG_BITMASK to 830
  2. Write parameters
  3. Refresh (value is still set)
  4. Disconnect
  5. Reconnect
  6. Refresh (value reverts to 0)

I just updated to 3.2.1 and I’m still experiencing this problem. I’ve tried both APM Planner 2.0 and Mission Planner. Neither will get this value to stick. Any suggestions?

2

It turns out my dataflash storage has become dislodged or a solder has gone bad. This is why I cannot enable logging.

3

If you are referring to the SD card have you tried removing and replacing the card, or using another SC card?

4

How you solve this problem?

“It turns out my dataflash storage has become dislodged or a solder has gone bad. This is why I cannot enable logging.”

5

I have the same problem with my apm. How did you fix the problem. I am going crazy.