When I use the ground station to configure the serial port on pixhawk6c, I can only find the configuration of telem1 and telem2, but I can’t find the configuration of telem3 on my board. Although I have configured the following serial ports, it is not successful
- SERIAL0 → USB
- SERIAL1 → UART7 (Telem1) RTS/CTS pins
- SERIAL2 → UART5 (Telem2) RTS/CTS pins
- SERIAL3 → USART1 (GPS1)
- SERIAL4 → UART8 (GPS2)
- SERIAL5 → USART2 (Telem3) RTS/CTS pins
- SERIAL6 → USART3 (USER)
Thank you very much. I’ll try it now
I succeeded. Thank you again