Hey everyone! I’m new to the forum and I hope to learn a lot!
I’ve built a Titan Cobra 3D printed drone Titan Cobra VTOL — Titan Dynamics
It’s turned out heavier than I’d hoped, but I’m doing hover testing now.
My main concern is that while set up in QLoiter or even QHover, the throttle response is so slow that I’m afraid it would fly away! I push up the throttle and it has a delay, but when it kicks in (and I’m holding it down so I don’t crash it), it takes a second or two after I put the throttle back down for the motors to stop trying to lift the thing.
I push up on the throttle, in a second the motors spin up, and I push down, and it takes what seems like forever for them to stop the thrust.
I feel like there’s some setting I’m missing. Does anyone have any ideas here? I don’t want to let this thing go when I can’t control the height!
I was hoping to try a completely manual mode, but “Manual” doesn’t seem to be a valid mode?
Thanks!