Hardware:
- Pixhawk 2 (Cube)
- Here + GPS
- Sabertooth 2x25
- 24VDC system
- 2- LiPO @ 12V
- FS-iA6B RX
- FS-iA6 TX
- (No telemetry)
Ground Station:
Mission Planner (Newest)
Hi, I have ran into an issue with my rover set-up. It seems after arming and manually controlling the rover, I will get maybe a few feet before my rover “resets” and I have to manually arm it again. I have looked at the forums, but I’m not so sure it’s a brownout as my logs aren’t showing this. I’m a noob so I might not be right.
The Sabertooth doesn’t appear to be losing power as the indicator light stays solid.
Any insight is much appreciated.
Links: (Not sure is one of them was actual test run)
https://drive.google.com/open?id=1Xets_hpt02zxo_7oMRfqeTODP23QNwbR
https://drive.google.com/open?id=1WVnGLplbm4_HImhPhfmIUOBjsxF40YDp
https://drive.google.com/open?id=1R7c7Un9YERO6HTZhILkhafjVAqm3cWfp