"Fuel Flow and Level Sensors" Configuration

“Fuel Flow and Level Sensors” Configuration.
Hello to everyone. I apologize in advance for any translation errors. I couldn’t set “Fuel Flow” for “Agriculture Drone”.
.
I adjusted the parameters according to the relevant page. “Battery Monitor 2” for 10lt tank. The settings I made are available in the pictures. (https://ardupilot.org/copter/docs/common-fuel-sensors.html)
.
When I run the spray system, there is no movement/change in “Battery Monitor 2”. .
It keeps giving “Battery 2 Low Falsafe” error.
.
But I don’t have any information about what’s next. I’ve gone through all the threads I could find here. But I could not find clear information until the end.
.
I would be very happy if experienced friends can explain in detail. It will benefit everyone.
.








1 Like

I’m looking for help from people with experience. I still haven’t fixed it.

Did you try setting BATT2_AMP_PERVLT to the number of mL per pulse (rather than the 17 specified in the parameter documentation and in your screenshot)? I’m working on one of these, too.

1 Like

Did you set GPIO for servo 10 and SERVO_GPIO_MASK set servo 10 ?
you have to search pulse per lit of your flow sensor and fill it in BATT2_AMP_PERVLT.