Cube carrier board compatibility

Hardware Vendors CubePilot/ProfiCNC/HEX
1

I have a Cube black on its original carrier board that is missing a port (not a crash, but ripped off when part of the aircraft was dropped). I also have a newer cube orange carrier board with the ADS-B receiver built in.

Will the Cube black work mounted on the Orange carrier board? Anything to be aware of or that won’t work/ require tweaks in ardupilot?

fwiw I don’t care about the ADS-B functionality

Big_James

2

It should work fine. the two are inter-changeable as far as the connector to the carrier is concerned.
If you use the ADSB carrier then Serial5 is dedicated to the ADSB even if you’re not using it.
So you might as well set it up anyway :slight_smile:

1 Like
3

Excellent. Thank you for confirming I’ll swap it over and have a tinker