Can we skip the parameter loading (Getting Parameters) when we connect FC via Mission Planner?

[SKFlying (Peter Chung)]

This may be a silly question, but it is asked in the demand that instability and discomfort can be resolved.

Another topic has already been suggested.

Too slow parameter load to MP 1.3.80 through RFD900 modems

Set these on both modems Air speed 200 Max window 80 RTSCTS Off Op Resend Off I also set BRD_SER1_RTSCTS,0 to ensure the Auto detection of RTS/CTS doesnt interfere. I also set the modem Tx Power to 27 - a bit lower power for relatively short range work - seems OK for a few kilometers, and I can safely run the modem from the serial port +5v power and I meant to say: SERIAL1_PROTOCOL,2 which it probably already is, but just checking.

If we can skip the parameter loading whenever we connect FC, it is more comfortable.

Another alternative would be to do some selected parameters.

[geofrancis ([𝙂𝙚𝙤])]

Its control+T to connect mission planner in read only mode without loading parameters.

[SKFlying (Peter Chung)]

Thanks very much. I didn’t know that.
I have to learn more about MP although it’s hard for a retired old flying model hobbyist to study.
Your information is very helpful!!

[Allister (Allister Schreiber)]

In the configuration page, for the Planner settings you can check “Params Download in BackGround”. You won’t be able to upload missions while this is going on, but you can still see much of what’s going on while the parameters are downloading and you aren’t stuck waiting behind the popup screen.

[SKFlying (Peter Chung)]

Thanks very much. Now I know there’s a useful feature.