Camera Gimbal in grey

ArduCopter Copter 4.4
,
1

Hi everyone

I have a problem with Camera Trigger and Camera Gimbal in Mission Planner;

Let me explain better:

I have a CUbe Black with rel. 4.4.4., Mission Planner ver. 1.3.81 and a 3-axis gimbal with integrated Shot/Rec management

In photogrammetry I need CH7 to produce the trigger for the shot but with the new release of Mission Planner, the GIMBAL CAMERA section is completely gray and disabled so I can’t make any Settings.

I have set RC7 in Camera Trigger and SERVO7 in RC Pass Throught but I can only manually control the shot and if I command from “Trigger Camera NOW” it releases the shot symbol but does not open the PWM on RC7

Do you have any advice?

2

Use the full parameter list.

The greyed out problem is a known one.

3

Thanks Amilcar for the reply,

In the parameters, however, I have already set RC7 in Camera Trigger and Servo7 in Pass Through but I still cannot drive the output via Camera Trigger NOW (when clicking on Camera Trig Now it releases the camera symbol but does not send any PWM to RC7); However, I can still shoot with the button from the remote controller
I don’t know any other solutions. Can you tell me if there are other parameters to change? Thank you