Auto arm when connect

Hardware UnSupported hardware
1

Hi to All
Im new to this, so please if someone can assist me, because I dont know how to solve this problem.
I bought a Apm2.8 flight controller to install in my baitboat. I have installed the fermware v245 but as soon as I connect the board on Mission Planner, the board arm itself. If I tri to disarm, it refuse .

2

Moved to Unsupported hardware. Suggest you replace that flight controller with a supported one.

3

I agree, but I have this one now, so isnt there a solution for this? Im sure Im just doing something wrong.

4

I’m sure there is but no one will remember what it is. I think V2.5 was the last version that supported Rover almost 10 yrs ago.

5

Thank you Dave, I appreciate your response.