Apm 2.8 power module calibration

Hardware Multirotors
1

Goodmorning,
-I have followed the calibration procedure of the power module, but the data are not memorized by the flight controller. Do you have any ideas to save data?

  • when i increase the throttle, after having set volts read by tester in static conditions, Vs don’t correspond with that of Wattmeter. Can someone help me?
    Best regards

Marco

2

After you type in the measured value you must press the TAB key on your keyboard or click outside of the measured voltage box.

Read this VERY CAREFULY:
http://ardupilot.org/copter/docs/common-power-module-configuration-in-mission-planner.html