Airspeed sensor question

Hardware Pixhawk 2
1

Plugged my mRo Digital Airspeed Sensor MS4525DO in CAN1 Port on the Cube and powered up… quickly realised my mistake and changed the connection to IC2 Port but there are no airspeed readings, have I fried the airspeed sensor? :slight_smile: CAN 1 Port is supposed to provide 12v and IC2 only 5v

Thanks in advance for your responses.

2

The can port should only be at 5v.
Make sure you have the airspeed enabled in parameters.

3

Thanks, James.

Yes, everything was activated in mission planer but readings were 0.
I will re-flash firmware and start again tomorrow.
Evgeni