after changing the values;
I flew the heli and it was good.
I don’t know if the vibration is still there?
I replaced the double side tape to the one that comes with the Pixhawk (3m thick hard foam )
I really had a hard time to calibrate the compass ;(
I tried over 25 times outside home, same locations I used to calibrate my old pixhawk
but this one refuse to give me a good result!
best I could get using the QGC is on the beginning of the green bar!
and I didn’t like it because the X: 420 something like over 400 as I remember !
and I re-calibrated the compass thinking things will get better, but now the best is on the yellow bar and most of the time on red!
its just frustrating! I know there is interfere but with what?
everything is aluminum even the compass cable I warped with aluminum tape! and away from anything!
just the metal screws that hold the mast and the little screw holding the round aluminum plate that the GPS set on it!
maybe the screws! but what I will have to use if I need to remove them! and why the old pixhawk GPS was super easy to calibrate and I had low offsets numbers!
please correct me if I am wrong…
thank you for all the time you spending with me to make it happen!
sep-14-2019.param (14.1 KB)