Servo_Auto_Trim always enable?

ArduPlane Plane 3.9
1

Hi all,

Read somewhere that for foam planes it´s good idea to keep de servo_auto_trim always enable.

As i was analyzing (not searching for nothing, only learning to :nerd_face:) the last 2 log´s I found one thing:

that command is always trimming as showed in this graphics:

pic1 pic2

I wonder if is better to turn it off, and time to time enable it,

Any opinions?

Thanks

2

It’s really up to you. If you know that your plane’s CG and setup will stay the same every time, you can disable it. Otherwise there is really no harm leaving it on.