Rc calibration and Iris Won´t arm


Yesterday i made RC calibration in Fs TH9X for iris

Now iris won´t arm when move left stick down and rigth. I made all procces, RC calibration, Esc Calibration & compass calibration.
Also, when i made ESC Calibration the thottle works fine and the motor are ok.
Is possible setting default to Rc for irs?
that images are from rc calibration

I’m not sure what the minimum value for the idle output on the throttle should be.

I had the same issue until I lowered mine below 1050 using transmitter trim. Your looks to be close but may be too high.