PX4 power using Pixhawk 2.1 power brick

Hardware Pixhawk family
1

Hello everyone. I am attempting to use a PX4 for my hexacopter, and to power it, I’m using the power brick that came with my 2.1. I made the cable according to the power diagrams, and it powers up just fine. However, I’m getting 0 reading for volts and current. I went into the setup in mission planner and tried to calibrate it, but it still shows zero. How should I be setting this up? Thanks in advance.

Pat

2

Double checked the cable as well. That’s correct. I guess on top of the 2.1 being a failure, the power brick is as well. I’ll buy a different one.