Pixhawk Lite & Current sensing

Archive
1

Hi all,

I’m building a mini-quad (250 for FPV) with a Pixhawk Lite (from GLB). So far so good, the little thing is flying pretty well (besides an CoG slightly on the back which seems to affect a bit the behavior on pitch) :smiley:

[youtube]https://www.youtube.com/watch?v=-EP8OxmQ0Cc[/youtube]

However, current sensing is not working. Voltage is reported correctly but current stays low during the whole flight. I’m using the following power module: ebay.com/itm/221772436078

Is anyone using Pixhawk Lite and has current sensing working? I doubt the distribution board is broken but I should check this. I’m wondering if the Pixhawk Lite may use a different analog port that the standard Pixhawk!?

Regards,
Cyril

2

I just noticed this forum is for “genuine 3DR Pixhawk” :frowning: Any appropriate one for China clones???