Pixhawk cube problem

Personally I may be boring, but it’s complicated for me to pay a thousand dollars on equipament without counting the country’s fees and the equipament does not work properly, it’s a bit frustrating.

Flying in manual - ok
Flying in stabilize - ok
Flying in auto - ok

Remove auto to manual enter in spin and crash.

Without radio control.

This is the third time this has happened.

I really need a light at the end of the tunnel.

Could you post your DataFlash log files as well?

Did I read correctly :
Without radio control, you pass from auto mode to manual mode, right ? But that is not good … Manual mode expect RC input … without the controller will surely use the lastest value or go on failsafe if you enable it.