Problem: I can’t program my holybro tekko32 f3 metal esc.
Configuration:
FC - Pixhawk 2.1 Orange Cube
ESC - holybro tekko32 f3 metal esc(65A)
Software: QGroundControl (ArduPilot), BLHeliSuite - both running on Mac.
I am able to make a connection, but I keep getting “Error - found no valid ESC configuration.”
smartdave
(Dave Glover)
March 26, 2020, 5:17pm
2
I have yet to get it to work on Cube Orange or a CUAV v5+ cube, I had to make an arduino interface board to program my ESCs
Problem resolved. I had to move my motor controls to the Aux outputs instead of the Main Outs. Found a note that the Main outs do not support the proper protocol
smartdave
(Dave Glover)
March 26, 2020, 5:47pm
4
Correct, only the aux ports support Dshot