Omnibus f4 pro broken Gps port and soldered wires

hello everyone,
I have a Omnibus f4 pro controller board and ublox m8n gps module. This module’s connector does not same with controller’s gps connector. Then I was decide remove the gps connector from board and solder gps wires to the pads but I had a mistake when ı was remove Rx pad with connector. this is terrible for me.

ı was solder to here. I crossed the rx and tx cables

and now ı take this messages from mission planer. and my gps doesnt connect any sattellite
image
mission planner

How can I solve this problem. And what is my main problem. thanks for everything.