No results when trying to spin the motors and had no other errors

ArduCopter Traditional Helicopter
1

Hello !

I have a problem with my hexacopter - Align 690L with controller PIxhawk2 . I calibrated all the functionalities and no error was displayed on my Mission Planner GSC. I also succesfully arm the drone but when i’m trying to spin the motors through my remote transmitter I do not get any results. Do you have any ideea about the cause for my problem?

Thank you in advance.

2

Hi Marina,
This is the Helicopter discusson group not Hexacopter. You can either post this to the ArduCopter group or the Copter 3.5 or Copter 3.6 discussions with in ArduCopter depending on what version you have loaded into your Pixhawk.

Good Luck!
Bill