hello everyone, I’m still a beginner and want to try accessing multipoint via the RFD900x hardware. I use 3 RFD900x hardware where RFD900x (1) as master, RFD900x (2) as slave 1 attached to the vehicle and RFD900x (3) as slave 2 connected to GCS. I set the airspeed rate to 224 to get maximum signal. Previously, when I accessed the GCS using the master or RFD900x (1) it could be accessed in the mission planner with a signal strength of approximately 56%, whereas when I used slave 2 or RFD900x (2) as the GCS, it was able to get a signal between 80% to 90 %. I think my last step was good progress, but when I tried to access it in the Qground control software it still couldn’t be accessed even with the settings I had tried successfully in the mission planner. My future target is to add one more slave RFD900x (4) as slave 3 on vehicle 2. However, before that I still have problems accessing Qground control with my settings. Can anyone help me why this might happen?