| i have a 10 inch frame. I have put the MicoAir405v2 F405 and loaded Ardupilot on it. i know there are some settings that i need to set up, but i cannot find the settings anywhere If someone know the settings to be entered in mission planner it would be greatly appreciated. The motors will not spin. I also have a Generic 4 in 1 ESC 50A 2-6s Micro Air Electronic Speed Controller Bluejay Firmware |
thanks |
| | |
What have you set up so far? Its a pretty open question so here’s some links to help out. If a specific step stumps you then ask away and we’ll help.
I have have set up everything like all the pixhawks i have only my other drones, but the MicoAir405v2 is connected to a 4 in 1 esc that runs dshot. From what have looked up there are some different settings for the 4 in 1 esc. I don’t know what they are and where they are in mission planner. I have tried to look through you tube videos but i can not find one that shows the changes i need to make. Is there a place i can find the settings for the 4 in 1 esc?
Not really. Same configuration as single ESC’s. Go here Dshot ESC’s
Configure for Dshot600 and Bluejay.
A 4 in 1 is just 4 ESCs on one board. The only thing different is the wiring. The FC doesn’t care if it’s a 4 in 1 or 4 singles.