Hi,
I have a clone Omnibus F4 V3 board running Arduplane V4.5.7 and I have an M10 Ublox GPS module wired up via UART. Baud rate is correct, I’ve tried with and without GPS_AUTO_CONFIG and set the protocol to UBLOX and I am always getting “No GPS” and EKF3 waiting for GPS Config. No point going outside because arduplane is not even recognising the module.
I did this with a different GPS module before which was also M10 Ublox and I had the same problem before that one broke for some reason. This module is brand new and I can’t arm, am stuck.
Any ideas? Thanks