Does ArduPilot support TuneRC Noodle flight controller?

ArduCopter Copter 4.6
1

Hi,
Just joined, but spent a long time reading trying to get my head, round ardupilot, used to use betaflight.
Initially looking to turn a remote control car into a rover, to get my head round how it all works, then transfer the stuff into my quad, to play with autonomous flight.
Would the board below work. And ifso what target would it be.

I already have a couple of fc from my quads, but neither have a baro and i cant calibrate either, although the missing baro is prob stopping it.

Thanks

Peter

2

I can’t help with your particular board, but check out this page to see what functions are necessary and which boards are commonly used with Ardupilot.

3

Thanks for the reply, i have spent a few hours reading the guides etc. I suppose i was initially hoping to use one of the fc i all ready have, as my betaflight quad, allready has gps, but no baro. (Ive ordered an external baro to try). Even when i flash the firmware to the board, i can connect in mp but, but cant calibrate, or get any readings from the board, although it does give me the no baro error, failed to initialise driver. Maybe this is holding back?.

4

Check in the Open and (most likely) Closed hardware pages for supported flight controllers.
The Noodle is not listed.

1 Like
5

ArteryTek based flight controllers aren’t supported and future support is unlikely.

1 Like