Hello,
I’m currently trying to make the OSD work using Dji O3 air unit, Fpv V2 goggles and matek f405 wte FC.
Dji O3 connected to uart6. Serial5 (corespondent to uart6 in f405) baud set to 115, protocol 42, options 0.
MSP_OPTIONS = 4 (BF fonts)
From Goggles, canvas mode set to normal.
If I set OSD_TYPE=5 (as recommended), I get nothing.
If I set OSD_TYPE=3, battery voltage is shown in the lower right corner (where the batt pictogram is) and vtx switches to full power mode when armed.
Is there anything to be done? I can’t fly the wing without telemetry.
Thanks in advance!