Connecting Raspberry Pi to flight controller over ethernet

APSync / Companion Computers
1

Hi
I have a Raspberry Pi 5 and a CUAV 7 Nano flight controller. Is it possible to connect the companion computer to FC over ethernet rather than using telemetry ports.
Regards
Mithun

2

You generally need to consume one telem port to service a serial to ethernet bridge. I have used these botblox dronenet kits and they just work

1 Like
3

Thankyou for the info.

4

Mind sending me your params? I can’t get it to work.Cube eth works but not dronenet.

5

I’ll get back to you soon

6

@madladdan See attached. We built firmware support for PPP for CubeOrange+, configured a can port for configuring the dronenet per their instructions, then configured the cube as below. Note the NET_* params. If you have specific questions, open a new thread and @ me.

net.param (20.3 KB)