Servers by jDrones

Com port problem

(Chuck Sley) #1

When I connect the Pixhawk 2.4.8 to my computer I can hear the computer see it and see the device. In devices and printers, It see’s it as a PX4 FMU (com106) for a few seconds and switches to Cube Black. When I try to connect to Mission Planner nothing shows up in the ports. I think this is a driver problem. Please help!

1 Like
(kailashp) #2

HI, did you resolve this issue. Its similar to mine except my port disappears after a few seconds rather then changes. This happens when I load older firmware. The firmware does not load properly and I cannot connect to the vehicle.

(Michael Oborne) #3

Make sure you have installed mission planner from MSI recently. This installs drivers. Latest version is 1.3.67